Filters & Views

In addition to the plain visualization of your coded data in the Time Line Chart, the available filters and zoom functionalities allow you to get statistical details on any part of your data.

Note: The functionalities, described in this section, influence the values in the statistics, because they alter the current view on your data.

INTERACT offers the following functionalities, to change the number of displayed Codes, after you have opened the Time Line Chart:

oManual Zoom - Zoom in on just part of your data using your mouse a described in Zoom in on your data.

oIdentify what happens during specific Events - Find all co-occurrences for a specific Code. The Trim on Code filter virtually removes all Events, that where coded outside time frames covered by the selected Code. Read Trim on Code filter

oCreate new Events for co-occurring Codes - Find all sequences where a combination of multiple codes overlap and create new Events for all situations found with the Co-occurrence Filter.

oInterval based zoom - Zoom-in and jump through your data, based on a specific time interval, using the Time-based interval functionality. Read Time based Interval Selection for details.

oCode based zoom - Zoom-in and jump through your data, based on a certain Code based interval, with the Code based interval functionality, as described in Code based Interval Selection.

oRemove Extremities - Virtually remove extremely long or short Codes using the Duration filter.

IMPORTANT: The statistics, exports and analysis routines available within the Time Line Chart, always reflect the data currently visible in the Time Line Chart. If e.g. you are ‘zoomed in' on just a part of your data, only this part is taken into account.