Each line in an INTERACT document has a separate transcription field. You can use this field for:
oTranscripts
oComments
oMemos
oDescriptions
o...
INTERACT does offer some special Text Analysis routines that are only applied to text entered into this specific Transcript field. There commands are available on the Text tab:
Available Commands
Word Count |
|
 |
Selected - Apply transcript analysis to selected Events only. |
|
DataSets - Apply transcript analysis to all Events of the selected DataSet(s) |
 |
Options - Make a selection among the available options to optimize the transcription analysis. |
Advanced |
|
|
Text Analysis - Special workflows that can be applied to text in the transcription field. |
|
Convert tagged #words into Codes - Routine that allows you to turn specific words in the transcript area into Codes. |
Note: The content of the transcript field is treated differently from the content of the class columns. That content does NOT occur in the regular Statistics, NOR any of the Code-based Analysis routines.
Transcript Position
Per default, the position of this field is at the bottom of your screen:
You can also display this Transcript field as a column:
You can change the position of the transcript field in the Main Layout Settings.
IMPORTANT: If you display the Transcript field as a column, all entries inside the transcript field of the Group and the Set lines are NOT displayed per default. If you need that information, additionally activate the option Show transcript also for Groups and Sets.within the Main Layout Settings.